Frequently Asked Questions

How do I set up my sprayer?

  1. Fill sprayer 1/2 full of water.
  2. Close agitation and filter purge completely.
  3. With hydraulic flow at lowest setting, turn the pump on.
  4. Set dead head pressure 40 psi above desired spray pressure, not to exceed 120 psi.
  5. Open agitation about 5-8 psi.
  6. Finally, open filter purge about 5-8 psi.
  7. These are initial settings, additional adjustments may be required.

How do I know what tip to use?

How do I winterize my sprayer?

  1. First, completely rinse tank and boom lines with water to purge any residual chemical.
  2. Then, drain as much water as possible and fill the rinse tank with up to 15-20 gallons of RV antifreeze.
  3. Draw RV antifreeze from rinse tank into the solution tank as if you were flushing your sprayer.
  4. Run RV antifreeze through the rinse balls.
  5. Once all antifreeze is transferred to the solution tank, run the chemical inductor to remove all water from lines. (If applicable)
  6. Then, run antifreeze through booms, making sure antifreeze gets out to the end of the boom.
  7. When antifreeze reaches the boom ends, shut the pump and booms off.
  8. Finally, remove 1 or 2 nozzles from each section to release any excess pressure.
    • DO NOT RUN PUMP DRY

How many gallons per acre can I spray?

90' boom
MPH GPA GPM PSI
15 27 73.63 30
12 32.5 70.9 30
10 39 70.9 30
8 48.5 70.54 30
6 65 70.9 30
4 98 71.2 30

How often should I calibrate my tips?

How do I keep my nozzles from drizzling on headland?